Gloss Tools

Filament Usage Calculator

Check before you print: convert filament length to weight and back by diameter and material density, estimate what is left on a spool from its gross and empty weights, and price one print from the spool's price.

Mode, diameter, material and values

Mode
Diameter

Fixed nominal densities (g/cm³); applies in every mode.

Above 0, at most 100000 m, up to 3 decimal places. Active only in Length to weight mode.

Above 0, at most 1000000 g, up to 2 decimal places. Active only in Weight to length mode.

Filament plus spool on the scale; above 0, at most 100000 g, up to 1 decimal place. Active only in Spool remaining mode.

Common empty-spool weights, or choose Custom for your own measurement. Active only in Spool remaining mode.

0–10000 g, up to 1 decimal place. Active only when the preset is Custom.

Above 0, at most 1000000, up to 2 decimal places. Active only in Print cost mode.

Filament weight without the spool, commonly 1000 g; 1–100000 g, up to 1 decimal place. Active only in Print cost mode.

Your slicer's estimate for this print; above 0, at most 1000000 g, up to 1 decimal place. Active only in Print cost mode.

A display label only; no exchange-rate conversion. Active only in Print cost mode.

Nothing calculated yet. Enter values or load the example, then press “Calculate”.

How it is calculated, and limits

Weight per metre = cross-section (π × radius²) × material density: 1.75 mm filament has a cross-section of about 2.405 mm², one metre of it has a volume equal to that many cm³, and multiplying by the density (g/cm³) gives grams per metre. Length-to-weight, weight-to-length, spool remaining and cost all derive from that figure, with no rounding until the single display rounding.

Spool remaining = gross weight − empty spool weight, divided by the weight per metre for the remaining length; print cost = spool price × filament used ÷ spool net weight (a linear estimate), with the currency shown as a label only. This tool does not read G-code or slicer files, does not estimate supports, skirts or flow differences, and does not guarantee a slicer's usage figure.

FAQ

Why does my slicer's weight differ?
Slicers compute from actual extrusion paths and flow; this tool converts from nominal diameter and density, so small differences are expected.
How do I get the empty spool weight?
Weigh a finished spool of the same kind or check the maker's published value; it can vary between batches.

Everything is calculated locally in this page. Your input is not uploaded, stored or logged.